Firmware V1 documentation ยท V1.0-rc54-2d701ce
Koheron products currently ship with firmware V0.x by default. Firmware V1 is under active development and is not publicly available yet.
Contact us if you would like early access or want to evaluate V1 firmware on your device.
vdrop
Read or set voltage-drop compensation values in V, where supported.
Usage
>> vdrop
0.200
>> vdrop 0.3
0.300Product behavior
| Product | Access | Write arguments | Read response | Notes |
|---|---|---|---|---|
| TEC200 | Normal write | vdrop <pnp_drop> <npn_drop> |
PNP and NPN H-bridge voltage drops in V | The response has two fields: <pnp_drop> <npn_drop>. Both arguments are required when writing. |
| HTC200 | Normal write | vdrop <drop> |
FET voltage drop, configured setpoint, and drop error in V | The response has three fields: <fet_drop> <drop_setpoint> <drop_error>. |
| DRV700 | Read-only | none | monitored FET voltage drop in V | The write form is not available. |
Notes
Use floating-point values in V. Because vdrop readback is product-specific, host software should parse the response according to the connected product instead of assuming a single scalar value.