Koheron products currently ship with firmware V0.x by default. Firmware V1 is under active development and is not publicly available yet.
Contact us if you would like early access or want to evaluate V1 firmware on your device.
muxon
Read or set the UART multiplexing state.
With no argument, muxon prints the current mode. With 0, 1, or 3, it updates the mode when the current access mode allows the change and prints the current state. Other values are invalid.
Mode bits are: bit 0 requires an address header; bit 1 allows unaddressed commands. Mode 3 suppresses the prompt and echo while accepting both addressed and unaddressed commands. Use it only on a dedicated point-to-point UART; an unaddressed command on a shared UART may be executed by every controller.
Usage
>> muxon
0
>> muxon 1
1
>> muxon 3
3Notes
Set the board ID with bdid before enabling multiplexing. See UART multiplexing.
Use save after changing muxon if the multiplexing state should be restored at boot. The saved value is loaded only when the CFG switch is set to 1 at boot.