Set up a USB serial connection between a host and a Zynq board
- Connect the serial port of the board to your computer USB port.
- Run a terminal emulator
- Edit Configuration
- Port:
/dev/ttyUSB0 - Baud Rate: 115200
- Edit Configuration
- Baud Rate: 115200
- Reboot the board
We use here gtkterm to connect to the board.
$ sudo apt-get install gtkterm
$ sudo gtkterm
Go to Configuration> Port and edit the following:
If you don’t know which USB port is in use, you can run:
$ dmesg | grep ttyUSB
We use here Tera Term (download) to connect to the board.
Go to Setup> Serial port... and edit the following:
250 MSPS acquisition board
2190 €
Koheron ALPHA250 is a Xilinx Zynq development board with 100 MHz RF front end. It features two 14-bit ADC channels and two 16-bit DAC channels, both at 250 MSPS, clocked by an ultra-low jitter clock generator. It includes 4 channel 24-bit ADC and 4 channel 16-bit DAC. The board comes with open source reference designs.
