Koheron DRV100 drivers are compact, ultralow noise laser drivers, designed to operate narrow linewidth laser diodes. Power supply can be as low as 3 V. They can be directly operated with a switched supply thanks to a very high noise rejection. Laser current can be adjusted with a manual potentiometer.
|Laser current||0 - 40 mA||0 - 200 mA|
|Supply voltage VS||3 - 15 V (VS = V+ - V-)||3 - 15 V (VS = V+ - V-)|
|Compliance voltage||4 V||4 V|
|Current monitor||7.2 mV / mA||1.5 V / A|
|Current monitor output impedance||1 kΩ||1 kΩ|
|Temperature coefficient||50 ppm / °C||50 ppm / °C|
|RMS noise (10 Hz - 1 MHz)||55 nArms (up to 60 nArms)||320 nArms|
|Current noise density (1 kHz)||52 pA / Hz1/2||250 pA / Hz1/2|
|Current limit||42 mA||200 mA|
|Slow start (90 % setpoint)||490 ms||490 ms|
|Dimensions||38 mm x 38 mm x 12 mm||38 mm x 38 mm x 12 mm|
|Compatible lasers||Floating diodes / Anode-grounded||Floating diodes / Anode-grounded|
More Laser Drivers
The DRV100 laser driver current noise was measured across a 30 Ω resistor for the 40 mA laser current version (A-40) and a 5 Ω resistor for the 200 mA laser current version (A-200).
- 2: Added laser enable switch, moved terminal blocks